DSPRelated.com
Forums

getting error when try to connect..

Started by vipul agrawal April 11, 2008
hi,
Actually i m using dsp processor kit ezdsp tms320f2812 from spectrum digital
incorporation..

i have programmed the board successfully.But my problem is that, now when i
am trying to connect the board using ccsv3.1 compiler through emulator i
m getting following error ,
Error connecting to the target:
Error 0x80000200/-1031
Fatal Error during: OCS,
Device driver: Problem with the Emulation Controller.
It is recommended to RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.
Sequence ID: 0
Error Code: -1031
Error Class: 0x80000200
I/O Port = 378

Board Name: F2812 eZdsp
Cpu Name: cpu_0

Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.

i have also tried to program the processor using Sdflash (for seriel
programming),but there also i m getting ' failed to connect 'error .

so i want to know that whether my processor has damaged or thare is some
other problem??

thank you.

regards,

vipul.