Hi,
In our development we must disconnect from the device in CC to allow for
a board reset. We can disconnect, reset the device, and reconnect just
fine. However, after a certain number of times, CC gives this warning
each time a connection is made:
"WARNING: Too few RTDX Host Buffers
You have enabled RTDX on more CPUs than there are RTDX buffers.
You should configure RTDX to have at least as many host buffers as there
are CPUs which will simultaneously transmit data to the host.
Failure to do so may result in data loss."
Well, we are only using one 5509 CPU. How do we configure CC so that it
knows we only have 1 CPU?
--
Michael
_____________________________________