Hi all, I am using C6711 DSK, CCS 2.0. I really had doubts in my program cycle count. I was profiling 1 single printf statement and gives me the result of 34600 + cycle. I believe printf should only takes around 3k cycles? Do you have suggestions where I might be wrong? btw, I am using the example on tutorial\hello1.pjt. Thanks in advance. regards, Jonathan -----Original Message----- From: #JONATHAN SANITO# Sent: Thu 2/20/2003 4:52 PM To: Cc: Subject: Cycle count problem Hi, I tried one of the CCS tutorial on PBC, 'modem.pjt' to understand more about cycle count. It turns out that the code profiled result differently from the one in the help file. The different was quite significant. the cycle count in the CCS tutorial gives about 26 k cycles, and when i run it (using the same project configuration, no changes) i got the result about 15 times more for the cycle count. I wonder what is suppose to be the problem, any ideas? How to actually counts the # of cycles correctly? I have doubts because my code running on C6711 DSK compare to the same code running on P3 333, runs much slower (shouldn't be right?). on my 6711 which I believes got the clock speed 150 mhz runs about 6 - 7 times more. Btw, in P3, i profile my code using Rational Quantify. regards, Jonathan |
Printf 30K cycles?
Started by ●February 21, 2003