Forums

Debugging four TMS320C6201

Started by Thomas Schwere December 11, 2000
Hi all

We developped a board with four C6201 in the JTAG chain and want to
debug them with the XDS510 Emulator and Code Composer Studio Debug Tools

1.20. The DSPs are the only devices in the JTAG chain. The Emulator is
connected as in the TI application note SPRA439, figure 5 with signal
buffering.
In the CCS Setup we define four DSPs, but when we start CCS, the error
message "Can't initilaze target dsp..." appears. All the other settings
are correct, because with only one DSP in the chain it works properly.

Does anybody have experience with this stuff or did encountered similar
problems?

Thanks in advance.

Thomas

--
//\\\\
| ~ ~ |
( O O )
___________________________________oOOo______( )_____oOOo_______

Thomas Schwere Phone: +41 1 445 16 61
Supercomputing Systems AG Fax: +41 1 445 16 10
Technoparkstrasse 1 Url: www.scs.ch
CH-8005 Zurich Email:
Switzerland
Oooo
_________________________________________oooO______( )_________
( ) ) /
\ ( (_/
\_)