Forums

2189M EzLite IDMA

Started by Jaime Andres Aranguren Cardona November 20, 2003
Hello,

I am trying to IDMA boot the ADSP-2189M in the ADDU-2189M-EZLITE kit,
without success at all.

I' like to knoe if anyone in the group has been successful doing this,
to share about the experience. I'tried to follow all the rules from
the HW Manual an Datasheet, with no success at all. The only thing I
get is the FL1 led turned on, with a program which is supposed to make
it blink. What's worse, it doesn't event happen every time I try to
boot the DSP, so it's no "reliable".

Something else: how can I read back the program which was actually
written to the DSP, by using the 218x EzICE serial emulator??? This
could be nice to verify what's in the DSP!!!

Regards,

JaaC
Hello,

What happens??? I am quit sure that some people in this group have
done this before... I am just asking for a bit of help, c'mon! It's
been a long tiem, without replies at all!

I sill hope that I will get some advice with this subject.

Kind regards,

JaaC

jaime.aranguren@ieee.org (Jaime Andres Aranguren Cardona) wrote in message news:<14a86f87.0311201925.27cc091@posting.google.com>...
> Hello, > > I am trying to IDMA boot the ADSP-2189M in the ADDU-2189M-EZLITE kit, > without success at all. > > I' like to knoe if anyone in the group has been successful doing this, > to share about the experience. I'tried to follow all the rules from > the HW Manual an Datasheet, with no success at all. The only thing I > get is the FL1 led turned on, with a program which is supposed to make > it blink. What's worse, it doesn't event happen every time I try to > boot the DSP, so it's no "reliable". > > Something else: how can I read back the program which was actually > written to the DSP, by using the 218x EzICE serial emulator??? This > could be nice to verify what's in the DSP!!! > > Regards, > > JaaC