Forums

ask help about the TRST pin of dsp56f807

Started by paulchenwy January 4, 2003
In normal mode,the /TRST pin should be pulled high, and only
when entering debug mode,should this pin asserted with /RESET
signal.But I notice the schematics coming with the DSP56f807EVM
User's manual,that the signal J_TRST is pulled low,which means the
output pin TRST which is designed as RST=/POR * /J_TRST should be
normally low,if /POR is left floated,can anyone explain it?
Wish every one a happy New year!



The /TRST signal resets the JTAG tap controller. The /TRST signal should help low in a system operating in normal mode with no equipment attached to the JTAG port. If allowed to float the part can end up accidently capturing invalid signals via the JTAG interface and placing the part in a debug mode when this is not intended. Thanks.
 
- Bill
-----Original Message-----
From: c...@mails.tsinghua.edu.cn [mailto:c...@mails.tsinghua.edu.cn]
Sent: Friday, January 03, 2003 11:16 PM
To: m...@yahoogroups.com
Subject: [motoroladsp] ask help about the TRST pin of dsp56f807

     In normal mode,the /TRST pin should be pulled high, and only
when entering debug mode,should this pin asserted with /RESET
signal.But I notice the schematics coming with the DSP56f807EVM
User's manual,that the signal J_TRST is pulled low,which means the
output pin TRST which is designed as RST=/POR * /J_TRST should be
normally low,if /POR is left floated,can anyone explain it?
    Wish every one a happy New year!


_____________________________________
Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer.  You need to do a "reply all" if you want your answer to be distributed to the entire group.

_____________________________________
About this discussion group:

To Join:  m...@yahoogroups.com

To Post:  m...@yahoogroups.com

To Leave: m...@yahoogroups.com

Archives: http://www.yahoogroups.com/group/motoroladsp

More Groups: http://www.dsprelated.com/groups.php3


">Yahoo! Terms of Service.