Hi, I came back on a recent project with the DSP56F805EVM and when I tried to use the debugger I got this warning message: Breakpoint Warning Unable to set all the breakpoints requested. Some breakpoints may be disabled and will not stop the processor. So, I didn't set any breakpoint, the code was working fine some weeks ago and I had just reboot my PC. Can someone give me a clue on what's going on with the EVM board or CodeWarrior? Thanks, Bruno ------- Bruno Tremblay, Ing/Eng stag Gentec Inc. Automatisme et Contre/Automation and Control 2625 Dalton, Sainte-Foy Quec, Canada G1P 3S9 email: web : www.gentec.ca ------- |
|
Breakpoint warning with 805EVM
Started by ●January 23, 2003
Reply by ●January 27, 20032003-01-27
I would check to see if you have breakpoints defined in your files and
whether you are set up for hardware breakpoints or not. If you have hardware
breakpoints set, which is what you should have set if you are debugging from
internal flash, then you only have a single hardware interrupt to use. Debugging
from external RAM has some benfits in that you can set software breakpoints and
you can have as many breakpoints as you wish. But this does effect your speed of
operation if you have both your program and data external.
Thanks.
- Bill
|