About the 802 - does CW v5.0 support it? I went to Metrowerk's site,
and looked under the newer v5.1 "Detailed Features" for
CW/DSP56800.
All the other chips (801/3/5/7 etc) are listed under Supported
Processors, but not the 802.
Anybody know?
TIA,
-Pete.
Reply by isierra95●July 31, 20032003-07-31
Pete,
The version of the tools that supports the 802 is CodeWarrior
for DSP v5.1. If you going to the following link: http://www.metrowerks.com/MW/Develop/Embedded/DSP56800/Default.htm
this will give you information about CW for DSP 5.1. If you look
inside of the datasheet it will tell you which processors are
supported.
Supported Processors/EVMs
56F801 56F807
56F802 56F826
56F803 56F827
56F805
Regards,
Irene
--- In , "Pete Gray" <teknologikah@y...>
wrote: > About the 802 - does CW v5.0 support it? I went to
Metrowerk's site, > and looked under the newer v5.1 "Detailed
Features" for CW/DSP56800. > All the other chips (801/3/5/7 etc) are listed
under Supported
> Processors, but not the 802.
>
> Anybody know?
>
> TIA,
> -Pete.
Reply by Hutchings William-p23437●July 31, 20032003-07-31
The
56F802 is supported by the CodeWarrior v5.0. This version of CodeWarrior
probably does not have the 802 stationary or the flash config files, but the 801
ones can be used or the better choice would be to use the SDK stationary.
-----Original Message----- From: isierra95
[mailto:i...@yahoo.com] Sent: Thursday, July 31, 2003 6:33 AM To: m...@yahoogroups.com Subject: [motoroladsp] Re:
Codewarrior - 802 not listed
Pete, The version of the tools that supports the 802 is
CodeWarrior for DSP v5.1. If you going to the following link: http://www.metrowerks.com/MW/Develop/Embedded/DSP56800/Default.htm this
will give you information about CW for DSP 5.1. If you look inside
of the datasheet it will tell you which processors are supported.
Supported Processors/EVMs * 56F801 * 56F807 * 56F802 * 56F826 * 56F803 * 56F827 * 56F805
Regards, Irene --- In
m...@yahoogroups.com, "Pete Gray" <teknologikah@y...> wrote: > About the 802 - does CW v5.0 support it? I went to Metrowerk's site, > and looked under the newer v5.1 "Detailed Features" for CW/DSP56800. > All the other chips (801/3/5/7 etc) are listed under
Supported > Processors, but not the 802. > > Anybody
know? > > TIA, > -Pete.
_____________________________________ Note: If you do a simple
"reply" with your email client, only the author of this message will receive
your answer. You need to do a "reply all" if you want your answer to be
distributed to the entire group.
_____________________________________ About this discussion group: