|
Hi, I have uninstalled and reinstalled codewarrior on my PC. And now, I can't connect to board via parallel port. I think the desinstallation deletes something in registry and the reinstallation doesn't restore all the keys. But it's just an idea. Has someone got the same problem ??? Thanks in advance for your help. Maxime. |
|
|
"cannot connct to board"
Started by ●September 23, 2003
Reply by ●September 23, 20032003-09-23
|
Maxime, For the information that you provided I am assuming that this was able to work before. From my understanding it will not remove drivers and the only thing that gets removed from the registry is the software itself. We can try a few things to see if you can get around this issue: 1. If you are connecting to a EVM board make sure that the jumper is jumpered depending if you are going to use parallel port or JTAG. If the jumper is not jumpered you will get a error depending on which method you are using. 2. Make sure that parallel port is selected as your protocol 'Remote Debugging' settings. These are just a few suggestions that I have at this time. If you could provide more information would be greatly appreciated. Regards, Irene --- In , "max_mont" <max_mont@y...> wrote: > Hi, > > I have uninstalled and reinstalled codewarrior on my PC. And now, I > can't connect to board via parallel port. > I think the desinstallation deletes something in registry and the > reinstallation doesn't restore all the keys. > But it's just an idea. > > Has someone got the same problem ??? > > Thanks in advance for your help. > > Maxime. |
