In metrowerks codewarrior 5.2.1177, (with DSP56F807 demo board, and SDK 3.0)
what is the difference between using or not using the option "use flash
config file" in "flash setting -> M56800 Target setting".
When i use it, the transfert into target is very slow, and it works.
When i don't use it, the transfert is fast, and it doen't works : the conter
program jump directely in "asm void configUnhandledInterruptISR
(void)".
Why ?
Thank you.
Reply by Hutchings William-p23437●October 15, 20032003-10-15
You need
to use the flash configuration file when programming and running from flash. The
codewarrior tool uses this file to determine how to program the flash in the
part. When it is not specified CodeWarrior defaults to something that is not
correct for the part you are using and hence it does not properly program the
flash. Thanks.
-
Bill
-----Original
Message----- From: Lionel Degoutte [mailto:l...@rotronics.com] Sent: Tuesday, October 14, 2003 1:58 AM To: yahoo
dsp56f807 Subject: [motoroladsp] DSP56F807 Programming flash
Hello,
In metrowerks codewarrior 5.2.1177,
(with DSP56F807 demo board, and SDK 3.0) what is the difference between
using or not using the option "use flash config file" in "flash setting
-> M56800 Target setting". When i use it, the transfert into target is
very slow, and it works. When i don't use it, the transfert is fast, and it
doen't works : the conter program jump directely in "asm void
configUnhandledInterruptISR (void)". Why ?
Thank you.
_____________________________________ Note: If you do a simple
"reply" with your email client, only the author of this message will receive
your answer. You need to do a "reply all" if you want your answer to be
distributed to the entire group.
_____________________________________ About this discussion group:
