Hi, Has it always been the case where in order to see the input bit for a given timer channel that the Secondary Count Source has to be set to the counter channel number that is being used? I am just polling the input bit on timer D channel 3 to synchronize to an edge but it did not work until I set the Secondary Source to counter 3 input. I do not recall needing to do this but maybe I just forgot to make a note on it (along with all my other notes due to the shortcomings of the quadtimer section of the users manual). It is definitely something that should be in the User Manual. Thanks, Pete |
Quad Timer Input Question
Started by ●December 19, 2002