DSPRelated.com

(@InnovationAudio)


Good news. I do have the USBi. Crosscore and Sigmastudio. I have successfully connected the DSP to Sigmastudio. I used the EZkit to find which pins to connect the...
The development board has a separate board for the DSP chip/Jtag/USBi. So. If I just remove that board. It will be completely separated from the power supply.The...
So. I can connect the USB-I interface to the Eval board. Solder a Jtag header into the car audio DSP. Connect the two. Remove the USB power from the USB-I interface...
I'm not sure why you would think I'm trying to connect a different brand of DSP chip to Sigmastudio? "I'd like to add an upmixer software module to an existing...
I'd like to add an upmixer software module to an existing commercially available DSP (Car Audio) with a Sharc chip. I see the Jtag header on the circuit board...

Use this form to contact InnovationAudio

Before you can contact a member of the *Related Sites:

  • You must be logged in (register here)
  • You must confirm you email address