DSPRelated.com
About robkjn99

(@robkjn99)


Re: Estimating correct sampling rate for 802.11-like signal (for timing adjustment)

Reply posted 5 years ago (10/01/2019)
It turned out that it was a mistake in the positioning of the OFDM window (the time synchronization on the short training symbols was wrong due to a bad threshold)...Thanks...

Re: Estimating correct sampling rate for 802.11-like signal (for timing adjustment)

Reply posted 5 years ago (09/30/2019)
I had a quick glance back at my code and I definitely have a bug hidden somewhere in the synchronizer... I'll reimplement it with a 2X oversampling and try to find...

Re: Estimating correct sampling rate for 802.11-like signal (for timing adjustment)

Reply posted 5 years ago (09/26/2019)
Yes, it's an OFDM signal!Ok, then I'll have to debug a bit more my synchronizer... :SThanks a lot for your help!! :)

Re: Estimating correct sampling rate for 802.11-like signal (for timing adjustment)

Reply posted 5 years ago (09/26/2019)
Hello! Thanks for your answer!I am in the 20 PPM range, thus well below your threshold, but I still have a lot of noise in the constellation even in trivial situations...

Estimating correct sampling rate for 802.11-like signal (for timing adjustment)

New thread started 5 years ago
Hi,I am sorry if my question might look trivial to you, but I have several books and papers scattered on my desk and still I cannot find a good answer to it (possibly...

Use this form to contact robkjn99

Before you can contact a member of the *Related Sites:

  • You must be logged in (register here)
  • You must confirm you email address