Flashing code on to ADSPBF538

Hi,

I have an application code written in C, which i am trying to flash it on to the target board that uses ADSPBF 538F !

Can anybody tell me the steps that has to be followed ?
I found an online doc which i hv attached here http://www.analog.com/UploadedFiles/Application_Notes/3129643584387183785EE_333_Blackfin_Rev_1_1_08.pdf
I tried following the steps but here i used the .exe and .ldr files of my project .
It gives me an error in the step where i try to load the driver using .exe file !

Any suggestion or anybody who had similar problem pls let me know.
Also is there a possibility that my code is not working right ?

Thanks and regards

Chethana Puttaswamy

---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now. Start a New Thread

Hi Chetana,

Through flash loader you can only load *.ldr files in "Intel Hex, ASCII and
in Binary formats",
but you can not load *.dxe files (instead to *.exe, *.dxe files are
generated in ADSP).

--
Best Regards,
Abhishek

On Wed, May 7, 2008 at 9:25 PM, chetana np wrote:

> Hi,
>
> I have an application code written in C, which i am trying to flash it on
> to the target board that uses ADSPBF 538F !
>
> Can anybody tell me the steps that has to be followed ?
> I found an online doc which i hv attached here
> http://www.analog.com/UploadedFiles/Application_Notes/3129643584387183785EE_333_Blackfin_Rev_1_1_08.pdf
> I tried following the steps but here i used the .exe and .ldr files of my
> project .
> It gives me an error in the step where i try to load the driver using .exe
> file !
>
> Any suggestion or anybody who had similar problem pls let me know.
> Also is there a possibility that my code is not working right ?
>
> Thanks and regards
>
> Chethana Puttaswamy
> Start a New Thread