Dear All,
I was tring to connect TMS320VC33 boad to WIN2K computer using parellel poat
cable.After softwear and hardwear implimented ,While I was tring to give reset
command an error massge appers 'Host port communication error'-check
power supply, connections,A?D loading ,expansion bus loading,A slow DSP require
HPI time out increse.The red and green LED lighted up.
An advice is highly appreciated.
Thanks
Mark
Communication port reset
Started by ●May 11, 2006
Reply by ●May 23, 20062006-05-23
Have you loaded the parallel port drivers? These drivers are not
distributed by TI.
Best regards
Keith Larson
m...@ee.pdn.ac.lk wrote:
> Dear All,
> I was tring to connect TMS320VC33 boad to WIN2K computer using
> parellel poat cable.After softwear and hardwear implimented ,While I
> was tring to give reset command an error massge appers 'Host port
> communication error'-check power supply, connections,A?D loading
> ,expansion bus loading,A slow DSP require HPI time out increse.The red
> and green LED lighted up.
> An advice is highly appreciated.
> Thanks
> Mark
>
distributed by TI.
Best regards
Keith Larson
m...@ee.pdn.ac.lk wrote:
> Dear All,
> I was tring to connect TMS320VC33 boad to WIN2K computer using
> parellel poat cable.After softwear and hardwear implimented ,While I
> was tring to give reset command an error massge appers 'Host port
> communication error'-check power supply, connections,A?D loading
> ,expansion bus loading,A slow DSP require HPI time out increse.The red
> and green LED lighted up.
> An advice is highly appreciated.
> Thanks
> Mark
>
