software radio

Hi folks,

I am looking for literature that describes either the TX or RX (or both)
chains for a software radio with the following (ideal) constraint:

the radio uses digital FIR filters (post ADC/pre DAC) that operate between
100MHz and 300MHz (maybe a singlerate FIR or an FIR that interpolates into
this range or a decimation FIR that downsamples from this range).

Failing that, any literature that gives a nice simple TX/RX chain with
numbers that could be scaled up(down?) would be great.

I have found quite a lot of stuff on the web and via IEEE publications but
most of it seems to be lower rate than I am looking for.

Many thanks for your time,

Ken

-- 
To reply by email, please remove the _MENOWANTSPAM from my email address.

I don't know if this might be close or not.

http://www.proaxis.com/~boblark/dsp10.htm


"Ken" <aeu96186_MENOWANTSPAM@yahoo.co.uk> wrote in message
news:bj23bo$2oa$1@dennis.cc.strath.ac.uk...
>
> Hi folks,
>
> I am looking for literature that describes either the TX or RX (or both)
> chains for a software radio with the following (ideal) constraint:
>
> the radio uses digital FIR filters (post ADC/pre DAC) that operate between
> 100MHz and 300MHz (maybe a singlerate FIR or an FIR that interpolates into
> this range or a decimation FIR that downsamples from this range).
>
> Failing that, any literature that gives a nice simple TX/RX chain with
> numbers that could be scaled up(down?) would be great.
>
> I have found quite a lot of stuff on the web and via IEEE publications but
> most of it seems to be lower rate than I am looking for.
>
> Many thanks for your time,
>
> Ken
>
> -- 
> To reply by email, please remove the _MENOWANTSPAM from my email address.
>
>