Code Composer Studio v3.3 and Matlab 2008

Hello

I am new at CCS and Simlink interface. I improved a model with Simulink perfectly. I used Matlab 2008a. There is TMS320f2812 eZdsp kit and Code COmposer Studio c2x eZdsp kit Tools 2.21 that was delivered with the kit in our school. Now I can't use this CCS version with Matlab 2008a. When I press Ctrl+B in my model, it gives an error like that;
"This version of the Embedded IDE Link CC does not support your
version of Code Composer Studio(TM) IDE.
The Code Composer Studio(TM) version supported in this release is 3.3."

But I cannot find this version. What do you suggest?
If anyone have this program, could you please send me the program or a link?

I am very depressed about it.

Thank you very much from now.

Regards.... Start a New Thread

Mera-

> I am new at CCS and Simlink interface. I improved a model with
> Simulink perfectly. I used Matlab 2008a. There is
> TMS320f2812 eZdsp kit and Code COmposer Studio c2x eZdsp kit
> Tools 2.21 that was delivered with the kit in our school.
> Now I can't use this CCS version with Matlab 2008a. When I press
> Ctrl+B in my model, it gives an error like that;
> "This version of the Embedded IDE Link CC does not support your
> version of Code Composer Studio(TM) IDE.
> The Code Composer Studio(TM) version supported in this release
> is 3.3."
>
> But I cannot find this version. What do you suggest?
> If anyone have this program, could you please send me the
> program or a link?

First, you definitely want to be using CCS v3.3, which is widely used and will allow you to obtain accurate and prompt
online peer-to-peer support.

It should be straightforward to get a CCS v3.3 upgrade from TI for your eZdsp F2812 DSK. You might try asking your
Prof for the local TI FAE contact info, if that doesn't work then post on the TI "E2E Community" forum and explain the
situation.

TI is normally very good about helping University students stay current on tools the Univ has purchased.

-Jeff Start a New Thread