Hello, I am new on CPU programming also DSP. I have a job to make the
test board that has DSP56F801 to control the board.
May I ask for how to get start with this? Also, which any basics that I have
to know about using the CodeWarrior IDE version 5.6.1.1658 compiler.
Then, if I study to use "processor expert" on CodeWarrior which spent
a lot
of time to study it, is it worth to use this PE? or it is easier to write only
source codes and compile them?
Asking for any suggestions about develop DSP56F801 on CodeWarrior IDE 5.6.1.1658
Started by ●October 12, 2005
Reply by ●October 12, 20052005-10-12
Start by looking at the following short multimedia files. Each one is
about 2-3 minutes long and are the best way to get up the speed on
CodeWarrior and Processor Expert:
http://www.freescale.com/webapp/sps/site/prod_summary.jsp?
code=DSP56F801&nodeId27956292#Training_Reference_Material --- In motoroladsp@moto..., "pitchayav" <pitchayav@F...> wrote:
>
> Hello, I am new on CPU programming also DSP. I have a job to make
the
> test board that has DSP56F801 to control the board.
> May I ask for how to get start with this? Also, which any basics
that I have
> to know about using the CodeWarrior IDE version 5.6.1.1658 compiler.
> Then, if I study to use "processor expert" on CodeWarrior which
spent a lot
> of time to study it, is it worth to use this PE? or it is easier to
write only
> source codes and compile them?
>
about 2-3 minutes long and are the best way to get up the speed on
CodeWarrior and Processor Expert:
http://www.freescale.com/webapp/sps/site/prod_summary.jsp?
code=DSP56F801&nodeId27956292#Training_Reference_Material --- In motoroladsp@moto..., "pitchayav" <pitchayav@F...> wrote:
>
> Hello, I am new on CPU programming also DSP. I have a job to make
the
> test board that has DSP56F801 to control the board.
> May I ask for how to get start with this? Also, which any basics
that I have
> to know about using the CodeWarrior IDE version 5.6.1.1658 compiler.
> Then, if I study to use "processor expert" on CodeWarrior which
spent a lot
> of time to study it, is it worth to use this PE? or it is easier to
write only
> source codes and compile them?
>
