Tigersharc Hardware Issue

Started by chetrebeiro June 24, 2003
Hi All,

We are developing a Tiger SHARC based board, the design of which is
very similar to the AD-TS101S EZKIT LITE.

The core voltage(1.2V), IO voltage (3.3V) and clock (83.3MHz) seem to
be OK.
The Tiger SHARC is also recognized by the AD JTAG Emulator, and I am
able to check/modify the registers from VDSP++.

However, even though the BMS# pin strap is asserted during reset
(required to boot from Flash). There seems to be no activity on the
Address/Data bus for accessing flash.

Any suggestions as to what could be wrong.