|
Hello, Has anyone out there programmed the flash on the BF533 EZKIT using the Flashlink cable from ST Micro? I've hooked up everything according to the instructions and have run into some issues. One is that although I set the target device to the one in the schematic, the ID of the device in the chain seems to be different, according to an error message in the PSDsoft express 8.0. Another is I'm not sure which sector to program - is this the boot or the user sector? Thanks in advance. Steve C |
Programing BF533 Flask with Flashlink cable
Started by ●December 6, 2003
