Hello, I have a problem with loading the BP (bandpass) demo supplied with the VDSP software.. I tried it because I just got the Kit.. and the following happens: Target #256: Error #905 Communications TimeOut Target #256: Error #911 Maximum retry limit broken, Board is in an Unknown State Target #256: Error #14 Reset Board Error reading target memory. Address: 0x942b, Length: 1 Same for some other demo programs supplied. I read in the forum, it could be the serial link to the PC.. but how to set it up? and how to check? I am a little bit frustrated.. Thanks, Achim Vollhardt |
|
EZ-Kit Lite 21065L: BP demo does not load!
Started by ●January 8, 2004
Reply by ●January 8, 20042004-01-08
On Thu, 8 Jan 2004, avollhar wrote: > Hello, > I have a problem with loading the BP (bandpass) demo supplied with the > VDSP software.. I tried it because I just got the Kit.. and the > following happens: > > Target #256: Error #905 Communications TimeOut > Target #256: Error #911 Maximum retry limit broken, Board is in an > Unknown State > Target #256: Error #14 Reset Board > Error reading target memory. Address: 0x942b, Length: 1 > > Same for some other demo programs supplied. I read in the forum, it > could be the serial link to the PC.. but how to set it up? and how to > check? I am a little bit frustrated.. Sounds like the address to the serial port is wrong. someplace you tell vdsp what the serial port address is for your card, and I bet the default is not what you have. I'm not sure, but check under options or preferences to find the right place to enter it. Patience, persistence, truth, Dr. mike |