Hello all, I finally managed to load the EZKIT here after some software errors from my side.. Gunn.dxe and pluck.dxe from the installation itself work fine, but when I try to load BP.dxe (bandpass demo) I get the following error message: ------------ snip "d:\Analog Devices\VisualDSP\cc21k.exe" .\Debug\065L_hdr.doj .\Debug\Bp.doj .\Debug\Buffers.doj -T .\Bp.ldf -proc ADSP-21065L -L .\Debug -flags-link -od,.\Debug -o .\Debug\BP.dxe -map .\Debug\BP.map -flags-link -e [Error li2007] Out of memory in memory segment "seg_pmco" in "p0". While processing the input section "seg_pmco" from file "fir.doj" of size 0x1a words [Error li2007] Memory allocation errors. See the MAP file ".\Debug\BP.map" for details Linker finished with 2 error(s) 0 warning(s) cc21k: Fatal Error: Link failed Tool failed with exit/exception code: 1. Build was unsuccessful. ------------ snap Any idea what this could be? I use the bp.dxe unmodified as coming from the installation... Thanks Achim Vollhardt |
|
Can't load BP.dxe into EZKIT 21065L
Started by ●April 4, 2004
Reply by ●April 5, 20042004-04-05
Hello all, I finally managed to load the EZKIT here after some software errors from my side.. Gunn.dxe and pluck.dxe from the installation itself work fine, but when I try to load BP.dxe (bandpass demo) I get the following error message: ------------ snip [Error li2007] Out of memory in memory segment "seg_pmco" in "p0". While processing the input section "seg_pmco" from file "fir.doj" of size 0x1a words ------------ snap Any idea what this could be? I use the bp.dxe unmodified as coming from the installation... Thanks Achim Vollhardt |