Hi,
I am using a ADSP 21020 based board in EZLAB environment. The board
has 48 bit PM and 16 bit DM. I would like to know how to specify that
( probably in the architectural file) so that the SHARC 21020
simulator show the proper no of bits when loaded with the program.
regards,
SS
Memory Configuration
Started by ●August 4, 2006
Reply by ●August 4, 20062006-08-04
Santanu wrote:
>
> Hi,
> I am using a ADSP 21020 based board in EZLAB environment. The
> board has 48 bit PM and 16 bit DM. I would like to know how to
> specify that ( probably in the architectural file) so that the SHARC
> 21020 simulator show the proper no of bits when loaded with the
> program.
> regards,
> SS
Hi Santanu,
what version of the development software are you using? Specifically,
are you using *.ACH or *.LDF to specify the architecture?
Regards,
Andor
>
> Hi,
> I am using a ADSP 21020 based board in EZLAB environment. The
> board has 48 bit PM and 16 bit DM. I would like to know how to
> specify that ( probably in the architectural file) so that the SHARC
> 21020 simulator show the proper no of bits when loaded with the
> program.
> regards,
> SS
Hi Santanu,
what version of the development software are you using? Specifically,
are you using *.ACH or *.LDF to specify the architecture?
Regards,
Andor