|
Hi to All of you. I am currently interfacing a master slave configuration of the AD1819A to the ADSP-21065L SHARC processor. I was wondering if any one of you guys know how to daisy chain these codecs. My master is working well, but my slave codec doesn't seem to respond to stimuli though it outputs a codec ready bit. I am not sure if the index control registers of the slave codec has been programmed correctly. The app note by John Tomarakos, says that it writes to all data those that outputs it when we set the serial config register properly (0x74). Hope anyone of you could comment on this. Jaeson |
AD1819 master slave
Started by ●February 22, 2002
