Hi ALL,
I want WDCR and SCSR configuration details for watchdog reset. I have gone
through the data sheet and configure them as per my understanding. In my case
watchdog reset (I can monitor low reset signal at XRS pin using CRO) is
happening. Sometime it is re-executing a code and sometimes it is not !!! And
even if it is re-executing a code the WDFLAG bit in WDCR register is not getting
set to indicate watchdog reset. I think something is going wrong with my either
watchdog registers setting or command (cmd) file setting.
Here is my registers setting:
SysCtrlRegs.WDCR = 0x00AF;
i = 0;
// Monitor WDINTS bit to check the current status of WDINT signal
i = SysCtrlRegs.SCSR & 0x0004;
// WDINTS (bit-3) should be high to Re-configure Watchdog Timer in RESET
while (i != 4)
i = SysCtrlRegs.SCSR & 0x0004;
// Re-configure the watchdog to the RESET Mode
EALLOW;
SysCtrlRegs.SCSR = 0x0000;
EDIS;
Please help me guys... I am really fed up...
Thanks in advance..
Regards,
Sanjaykumar T.
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video
Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467