Source Code isn't being used in Debug Mode

Started by Brian C. Lane July 25, 2002
I've got a new/old problem. I have code with part that runs in flash
(at extended addresses in a 5402), and in RAM. When debugging using
JTAG I have never been able to step through the source of the code
copied to RAM (I'm assuming because the linker/debugger thinks its
still located at its origin the flash). But I have been able to step
through code that runs in the flash. But its stopped working. No
changes have been made to the project, and the odd thing is that when
I turn on mixed source mode it shows the correct assembly and
locations next to the 'c' code.

But the PC bar (yellow bar in source) never shows up anymore.

Anyone have any ideas as to how to fix this?



Brian C. Lane (W7BCL) Programmer
www.shinemicro.com RF, DSP & Microcontroller Design