|
I am having trouble switching the C5402 DSK to mircocomputer mode using DSP/BIOS. The way I did it was by changing the MP/#MC bit of PMST register value within the DSP/BIOS cdb file. However, my program does not run correctly afterward. It ran okay before when I used microprocessor mode. The MP/MC# bit was the only thing I changed. Are there anything I need to do? |
|
|
Using Microcomputer Mode with DSP/BIOS
Started by ●November 29, 2002
Reply by ●February 18, 20032003-02-18
|
All, Hopefully it is not a too late answer. To run 5402 DSK into correct MC/MP mode, there is a small switch on DSP board. I can not recall which is which. You can easily find the info on manual. Hopefully, it will help. Henry --- freesampleic <> wrote: > I am having trouble switching the C5402 DSK to > mircocomputer mode > using DSP/BIOS. The way I did it was by changing the > MP/#MC bit of > PMST register value within the DSP/BIOS cdb file. > However, my > program does not run correctly afterward. It ran > okay before when I > used microprocessor mode. > > The MP/MC# bit was the only thing I changed. Are > there anything I > need to do? > > _____________________________________ > Note: If you do a simple "reply" with your email > client, only the author of this message will receive > your answer. You need to do a "reply all" if you > want your answer to be distributed to the entire > group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > To Post: Send an email to > > To Leave: Send an email to > Archives: http://www.yahoogroups.com/group/c54x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ __________________________________________________ |
