|
I just received my new TMS320C54x DSKplus board from vendor today. I've managed to install my code explorer successfully. However, when I try to run selftest.exe, I got the following error: . . . HPIC write/read successful verifying HPIA Mode..... HPIA Mode write/Read Successful. Verifyig HPI Data (Increment) Mode.... Data (Increment) Mode Passed. Verifying Data (Static) Mode..... Data (Static) Mode Passed. Attempting 8 bit Data I/O..... 8 bit mode is functional. No response from Hint Interrupt signal *** Test Failed **** Furthermore, sometimes when I inserted the power connector into the DC-jack, green LED is not on. I've to plug & unplug it a few times to get the LED light on. When my LED is on & I plug in my earphone into analog out, my LED is off again. Is my board function properly? I need the answer ASAP so that I can inform my vendor. Thanks ! |
|
|
Please help me, it's urgent !!!
Started by ●September 21, 2000
Reply by ●September 21, 20002000-09-21
|
Hi. I encountered the same problem a month ago. However, my DSK is
working after I change my host PC from Pentium II to I. Feedback this to TI dsphelp and they still have no reply. Make sure your parallel port is configured to bi-directional. Try different ECP & EPP settings. Hope this will help. Good luck! Regards, Doreen > -----Original Message----- > From: [SMTP:] > Sent: Thursday, September 21, 2000 11:41 AM > To: > Subject: [c54x] Please help me, it's urgent !!! > > I just received my new TMS320C54x DSKplus board from vendor today. > I've managed to install my code explorer successfully. However, when > I try to run selftest.exe, I got the following error: > . > . > . > HPIC write/read successful > verifying HPIA Mode..... > HPIA Mode write/Read Successful. > Verifyig HPI Data (Increment) Mode.... > Data (Increment) Mode Passed. > Verifying Data (Static) Mode..... > Data (Static) Mode Passed. > Attempting 8 bit Data I/O..... > 8 bit mode is functional. > No response from Hint Interrupt signal > *** Test Failed **** > > Furthermore, sometimes when I inserted the power connector into the > DC-jack, green LED is not on. I've to plug & unplug it a few times to > get the LED light on. When my LED is on & I plug in my earphone into > analog out, my LED is off again. Is my board function properly? > I need the answer ASAP so that I can inform my vendor. Thanks ! > > > To Join: Send an email to > > To Post: Send an email to > > To Leave: Send an email to > > Archives: http://www.egroups.com/group/c54x > > Other Groups: http://www.dsprelated.com > |
Reply by ●September 21, 20002000-09-21
|
Make sure you have TI's latest selftest.exe. When I got my DSK last year, I had a similar problem. It turned out that versions <1.20 have a problem with HINT. You can get the latest from the ti web site. Regards, Eric wrote: > No response from Hint Interrupt signal > *** Test Failed **** -- Eric S. Hirschorn MultiGen-Paradigm, Inc Senior Software Engineer "A Computer Associates Company" (972) 960-2301 14900 Landmark Blvd, Suite 400 Dallas, Texas 75240 USA NOTE: All views expressed above are solely mine and do not reflect those of Computer Associates or of other CA employees. |
