Flash on c5402 DSK

Started by Unknown November 21, 2001
Good day.

Just upgrade CCS from 1.2 to 2.0 for my c5402 DSK. Tried to run the
example for flash but encounter some problem.

For CCS 1.2, after successfully programming the flash in HPI boot mode
(JP2 pin 1 & 2 short), depress the hardware reset button or recycle
power will result in the blinking of the 3 LEDs.

Forr CCS 2.0, according to the flash.txt document, I have to remove
the jumper of JP2 and recycle power. However, there is no blinking of
LEDs. Anyone has similar problem or can enlighten me on this issue?

Oh, here's wishing you a Happy Thanksgiving!

Thanks in advance,