|
Hi, I am trying to change the DSP speed in the DSP/BIOS config tool to 40MHz from 100MHz. When I save the change, it writes its config files, then when compiling it brings up errors about the syntax of the .s54 file which the DSP/BIOS config tool writes (improperly). How can I change the speed? I suspect it is making my program behave very erratically. |
|
|
change processor speed in DSP/BIOS config tool
Started by ●February 25, 2002
Reply by ●February 25, 20022002-02-25
|
Hi, Its easy to change the CPU clock easily using the internal PLL. You'll need to write the code for same however. Its also a good idea to verify the speed using a timer ISR just for surety. Refer to section 8 or reference set 1 on details about how to program the PLL. Sachin "ajs_edwards_uk" <> on 02/25/2002 08:14:31 PM To: cc: (bcc: Sachin Gupta/HSS) Subject: [c54x] change processor speed in DSP/BIOS config tool Hi, I am trying to change the DSP speed in the DSP/BIOS config tool to 40MHz from 100MHz. When I save the change, it writes its config files, then when compiling it brings up errors about the syntax of the .s54 file which the DSP/BIOS config tool writes (improperly). How can I change the speed? I suspect it is making my program behave very erratically. _____________________________________ Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. _____________________________________ About this discussion group: To Join: Send an email to To Post: Send an email to To Leave: Send an email to Archives: http://www.yahoogroups.com/group/c54x Other Groups: http://www.dsprelated.com ">http://docs.yahoo.com/info/terms/ |
