Hi all,
I compiled a binary with cg-tools 3.2.2 (from CCS V3.1). When I load and run
this binary on a DSK C5510 hardware it works for CCS 2.12.07 (which was shipped
with the DSK board).
But when I load the _same_ binary onto the same DSK board using CCS 3.1 --
there, after some frames of valid output suddenly the output gets erred. Has
anyone seen something like this before and what can be the reason for that?
Thank you.
same binary, same DSK and different output depending on CCS Version
Started by ●November 22, 2005