Forums

Re: Generating code with Simulink, Real Time Workshop and Code Composer 3.3

Started by waqa...@yahoo.com January 11, 2008
I tried to run C code generated by using Simulink and Real Time
>Workshop on Digital Spectrum DSK C6713. I am using CCS 3.3 , Matlab
>(14P3), Real Time Workshop ver 6. I was able to generate ANSI C
>successfully. The simulink model I used have only two blocks "Line In
>C6713 ADC" block directly connected to "Line Out C6713 DAC" with
>DSKC6713 Traget Preference block. This model suppose to transfer audio
>signal directly form Line In to Line out without any processing. When
>I run incremental build the model generates C code Ok and invokes CCS,
>loads and runs code in DSK C6713. However, I don't hear any sound
>either on head phone port or Line out port. I don't have any clue why
>I could not hear anything. Does anyone know why I could not hear the
>sounds? I appreciate any help on this. Thanks.
>
>Nabin Shrestha
hi nabin its waqas i am working on the same kit and trying to run the same model but i get a lot of errors in my case from simulink the ccs opens and then errors start coming are there any special setting sthat are to be done before implementing this model kindly please tell.

my mail is
w...@yahoo.com
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467