Hello All,
We are using our custom board which has DM6437 processor.
We are trying to boot the DSP from NAND Flash using on chip bootloader. We had
gone thr document spraag0d and its zip file.
We had created AIS file and burned it at block 1 onwards. We read back the
content and they are correct. So file writing is not issue we suppose.
Then the bootmode pins [3 to 0] are set to 0111 and fast boot is 0.
The bootloader version is 0x00010400, but still we are not able to boot up
board.
Is there any constraint that Fast boot should be 1. Is anyone try out this?
Thanks,
Amol
