hello, for the dsk6711, is the external 'clks' pin shared with the 'clkr' pin on the J2 connector when timing is set to external? thus when RRST_bar = XRST_bar = 0 , and RIOEN=XIOEN = 1 then 'clkr' becomes 'clks' i would like to use external timing to drive the receive and transmit on the same port, but transmit would recycle and re-transmit the external timing back out to be used as a master device. thnx chiko lee |
|
clks
Started by ●June 18, 2003
Reply by ●June 18, 20032003-06-18
plz ignore, i figure out the pin was not listed on spra711[error], but listed on D00982. what a little bugger this was, chiko --- silver_sparrow <> wrote: > hello, > > for the dsk6711, is the external 'clks' pin shared with > the 'clkr' > pin on the J2 connector when timing is set to external? > > thus when RRST_bar = XRST_bar = 0 , and > RIOEN=XIOEN = 1 > then 'clkr' becomes 'clks' > > i would like to use external timing to drive the receive > and > transmit on the same port, > but transmit would recycle and re-transmit the > external > timing back out to be used as a master device. > > thnx > > chiko lee > > _____________________________________ > Note: If you do a simple "reply" with your email client, > only the author of this message will receive your answer. > You need to do a "reply all" if you want your answer to > be distributed to the entire group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > > To Post: Send an email to > > To Leave: Send an email to > Archives: http://www.yahoogroups.com/group/c6x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ __________________________________ |