Hi.Every body. A simple question: how to write data from Mcbsp to memory space. Should I use EDMA? And if so ,how to configure the parameter of EDMA?If the data is 8-bit or 16-bit,would any error occur? I ask the question because I encounter a problem:when I use c6711 DSK to tranfer data from McBsp to EMIF memory space through EDMA, if the data width is 8 or 16, then only the data at word address(that is the lowest two bits are 00) can be written correctly, and data at other address are written 0. Who can explain the problem? Thank you. |
|
about c6711 mcbsp
Started by ●June 26, 2003
Reply by ●June 26, 20032003-06-26
Check the destination increment. - Andrew E. At 11:18 PM 6/26/2003 +0800, =?gb2312?q?Guo yang?= wrote: >Hi.Every body. >A simple question: how to write data from Mcbsp to >memory space. Should I use EDMA? And if so ,how to >configure the parameter of EDMA?If the data is 8-bit >or 16-bit,would any error occur? >I ask the question because I encounter a problem:when >I use c6711 DSK to tranfer data from McBsp to EMIF >memory space through EDMA, if the data width is 8 or >16, then only the data at word address(that is the >lowest two bits are 00) can be written correctly, and >data at other address are written 0. >Who can explain the problem? >Thank you. > >_____________________________________ >Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. > >_____________________________________ >About this discussion group: > >To Join: Send an email to > >To Post: Send an email to > >To Leave: Send an email to > >Archives: http://www.yahoogroups.com/group/c6x > >Other Groups: http://www.dsprelated.com >">http://docs.yahoo.com/info/terms/ |