This e-mail is subject to the disclaimer set out below. --- Hi spru401d.pdf has a chapter in the appendix about using the CSL apis without the dsp/bios config tool. I haven't done this however, and I'm sure you've already found this document? All I can suggest is perhaps updating to version 2.2 of ccs - quite a few of my problems were ironed out when I did this... Lesley-Ann -----Original Message----- From: Andrew Elder [mailto:] Sent: 15 July 2003 3:28 PM To: Subject: [c6x] C6xxx using CSL IRQ_ macros without DSP/BIOS Hi, About 2 years ago I wrote code using an older version of CCS and was able to configure interrupts using IRQ_ CSL calls without having to use CCS and DSP/BIOS. I have tried to repeat the above using CCS 2.12.14, but find there are conditions to using IRQ_configArgs() that say a DSP/BIOS .cdb file must be used. Is there any documentation on how to use IRQ_ macros to develop an application that DOES NOT use DSP/BIOS ? Has anyone done this ? Thanks, Andrew E. _____________________________________ Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. _____________________________________ About this discussion group: To Join: Send an email to To Post: Send an email to To Leave: Send an email to Archives: http://www.yahoogroups.com/group/c6x Other Groups: http://www.dsprelated.com ">http://docs.yahoo.com/info/terms/ --- This e-mail message is confidential and for use by the addressee only. If you are not the intended recipient, you must not use, disclose, copy or forward this transmission. Please return the message to the sender by replying to it and then delete the message from your computer. The Generics Group provides e-mail services for both itself and a number of its independent spin-out companies. The Generics Group shall not be held liable to any person resulting from the use of any information contained in this e-mail and shall not be liable to any person who acts or omits to do anything in reliance upon it. The Generics Group does not accept responsibility for changes made to this message after it was sent. |
RE: C6xxx using CSL IRQ_ macros without DSP/BIOS
Started by ●July 15, 2003
Reply by ●July 15, 20032003-07-15
Hi, About 2 years ago I wrote code using an older version of CCS and was able to configure interrupts using IRQ_ CSL calls without having to use CCS and DSP/BIOS. I have tried to repeat the above using CCS 2.12.14, but find there are conditions to using IRQ_configArgs() that say a DSP/BIOS .cdb file must be used. Is there any documentation on how to use IRQ_ macros to develop an application that DOES NOT use DSP/BIOS ? Has anyone done this ? Thanks, Andrew E. |
|