I need help in daughtercard peripheral connector (J2) of TMS320C6711 DSK. I
am looking for the way how can i control any of these pins ?
Pin# signal I/O Descp Pin# signal
I/O Descp
63 CNTL1 O Daughtercard control1 64 CNTL0 O
Daughtercard control
65 STAT1 I Daughtercard status1 66 STAT0 I
Daughtercard status
I just want to send a signal at output pin to a piece of hardware connected
via this connector. I am already using 2 timers and sending signals and
retrieving back successfully.
Thanks in advance
FaYsaL
_________________________________________________________________
Help STOP SPAM with the new MSN 8 and get 2 months FREE* http://join.msn.com/?pageatures/junkmail
Reply by Mike Dunn●October 14, 20032003-10-14
These are bits 27 & 28 [0x18000000 bit mask] of the IO ports
[0x90080000].
Stat0/1 are inputs & Cntl0/1 are outputs. You access them the
same way as the switches & LEDs. Refer to help file and GEL file for
info.
mikedunn
M FaYsaL <f...@hotmail.com>
wrote:
Hi all
I need help in daughtercard
peripheral connector (J2) of TMS320C6711 DSK. I am looking for the way how
can i control any of these pins ?
Pin# signal I/O Descp Pin# signal
I/O Descp
63 CNTL1 O Daughtercard control1 64 CNTL0 O Daughtercard control 65 STAT1 I Daughtercard status1 66 STAT0 I Daughtercard status
I just want to send a signal at output pin to a
piece of hardware connected via this connector. I am already using 2
timers and sending signals and retrieving back successfully.
Thanks in advanceFaYsaL
_________________________________________________________________ Help
STOP SPAM with the new MSN 8 and get 2 months FREE* http://join.msn.com/?pageatures/junkmail _____________________________________ Note: If you do a simple "reply"
with your email client, only
the author of this message will receive your answer. You need to do a "reply
all" if you want your answer to be distributed to the entire group.
_____________________________________ About this discussion group:
