|
Hi ! C6x , I have been trying to send frame of processed data periodically to Matlab by using RTDX. Here are some problems I couldn't figure out. I am using 6711 DSK with PCM3003 daughter card. I have used HWI for data acquisition and for output of the data. Here what I wanted to do is by defining a preiodic funtion which is responsible for for filling the specific buffer ( predefined buffer size) and send this frame of data to Matlab without affecting the application. Will it be possible ? I am wondering the priority of the hardware interrupt. Will it allow other funtions to occur when it is busy handling data processing. thanks in advance, Aziz, |
|
|
HWI and PRD
Started by ●February 4, 2004
Reply by ●February 5, 20042004-02-05
|
Hi! Could you make it a bit clear. You mean , to set up ( HWI or SWI) interrupt for processing periodic function in order to send the frame based data, am I right? Can I set a HWI again even I am using HWI for data processing ? Thanks. Aziz On Wed, 4 Feb 2004, rulph wrote: > Hi: > > I communicated with you before and I am not sure if you replied. > > I am using recently the C6713DSK for RTDX with MATLAB. Interrupt needs to > be set even though I used polling. > > Rulph Chassaing > > ----- Original Message ----- > From: "Aizezi Abuding" <> > To: <> > Sent: Wednesday, February 04, 2004 7:38 AM > Subject: [c6x] HWI and PRD > > > > Hi ! C6x , > > I have been trying to send frame of processed data periodically to > > Matlab by using RTDX. Here are some problems I couldn't figure out. I am > > using 6711 DSK with PCM3003 daughter card. I have used HWI for data > > acquisition and for output of the data. Here what I wanted to do is by > > defining a preiodic funtion which is responsible for > > for filling the specific buffer ( predefined buffer size) and send this > > frame of data to Matlab without affecting the application. > > > > Will it be possible ? I am wondering the priority of the hardware > > interrupt. Will it allow other funtions to occur when it is busy handling > > data processing. > > > > thanks in advance, > > Aziz, > > > > > > _____________________________________ > > Note: If you do a simple "reply" with your email client, only the author > of this message will receive your answer. You need to do a "reply all" if > you want your answer to be distributed to the entire group. > > > > _____________________________________ > > About this discussion group: > > > > To Join: Send an email to > > > > To Post: Send an email to > > > > To Leave: Send an email to > > > > Archives: http://www.yahoogroups.com/group/c6x > > > > Other Groups: http://www.dsprelated.com > > > > > > > > > > > > > |
