DSK6711 and microcontroller 8051

Hi Nalin,

I have done similar interfacing, Interfacing c6711 DSK to MSP430 microcontroller. The deal with me was I needed a parallel port for DSK as well as microcontroller and I dindt have extra parallel port to interface both of them ( nor cud I find appropriate extension slot or card or something) so I had to use 2 pc's.

But if you have enough ports to interface both of them simultaneously thru one pc then there is no need for another pc.

I havent ventured out in that direction ( as in connecting 2 borads to same pc) , so someone who already has mite be more helpful then me.

Hope this helps,

Tarang

On Wed, 12 May 2004 Nalin K Pithwa wrote :
>
>Hi,
>
>I am doing a project on TMS320C67x DSP starter kit with CCS2.1 on
>Win98. Simultaneouly, I have to code an 8051 microcontroller with
>a flash. Can I install the 8051 boards/software on the same PC
>which contains the C67x installation/CCS2.1. Will it create any
>conflicts ? Or would it better to install the 8051 boards/software
>on a separate computer ?
>
>I would be deeply obliged if someone can answer my question.
>
>Regards,
>Nalin Pithwa >_____________________________________
>Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer.  You need to do a "reply all" if you want your answer to be distributed to the entire group.
>
>_____________________________________
>About this discussion group:
>
>To Join:  Send an email to c...@yahoogroups.com
>
>To Post:  Send an email to c...@yahoogroups.com
>
>To Leave: Send an email to c...@yahoogroups.com
>
>Archives: http://www.yahoogroups.com/group/c6x
>
>Other Groups: http://www.dsprelated.com
>
>Yahoo! Groups Links
>
><*> To visit your group on the web, go to:
>      http://groups.yahoo.com/group/c6x/
>
><*> To unsubscribe from this group, send an email to:
>      c...@yahoogroups.com
>
><*