|
Hi, I am using TI provided PCI driver for DM642 EVM card, I was able to download my code correctly, and successfully have my code running after writing 1 to DSPINT in HDCR. I am trying to cause an interrupt for host to DSP after the code is running. I set the HOSTSW bit in PCIIEN and writing 1 to DSPINT in HDCR, and set up my ISR for INT13. However, I could not get any interrupt by doing so. What am I missing? Thanks in advance! Linda |
|
|
Host to DSP Interrupt through PCI for DM642 EVM Problem
Started by ●May 26, 2004
Reply by ●May 28, 20042004-05-28
|
Hi, I'm not using DM642 EVM, but we have a C64x system here. Did you enable the Int13 and the NMIE in the IER register ? How about the GIE in CSR register ? Regards, BehCS ----- Original Message ----- From: <> To: <> Sent: Thursday, May 27, 2004 2:37 AM Subject: [c6x] Host to DSP Interrupt through PCI for DM642 EVM Problem > Hi, > > I am using TI provided PCI driver for DM642 EVM card, I was able to > download my code correctly, and successfully have my code running > after writing 1 to DSPINT in HDCR. > > I am trying to cause an interrupt for host to DSP after the code is > running. I set the HOSTSW bit in PCIIEN and writing 1 to DSPINT in > HDCR, and set up my ISR for INT13. However, I could not get any > interrupt by doing so. What am I missing? > > Thanks in advance! > > Linda > _____________________________________ > Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > > To Post: Send an email to > > To Leave: Send an email to > > Archives: http://www.yahoogroups.com/group/c6x > > Other Groups: http://www.dsprelated.com > > Yahoo! Groups Links |
