converting matlab M-files to run in DSK 6711
Started by ●April 26, 2005
I'm doing a project regarding phase vocoder technique. I already have
the matlab m-files. is there any simple way to convert those m-files
so that it can be run in DSK 6711? :)
Reply by ●April 27, 20052005-04-27
hi
I don't think it is possible in MATLAB.
It is possible in simulink if you have your .mdl files.
regards
sreeni
edznin84 <edznin84@edzn...> wrote:
I'm doing a project regarding phase vocoder technique. I already have
the matlab m-files. is there any simple way to convert those m-files
so that it can be run in DSK 6711? :) Yahoo! India Matrimony: Find your life partneronline.
Reply by ●April 27, 20052005-04-27
hi,
Well this was something i tried very long back, bud couldn't succeed.
But i was given a link by some one from the groups.
check this mail:
> hi there
>
> were u able to get ur matlab program to work in the
> 6711DSK??
>
> if you havent then have a look at the following web
> page:
> http://eceserv0.ece.wisc.edu/~morrow/software/
>
> you need "TMS320C6X11 DSK to Matlab direct interface
> software"
> save the zip file and just extract it in to the
> folder tat you have the m-file, there
> is few examples to get you started...
>
> if you have found another method let me knw aswel!
> becas im trying to do the
> same thin
>
> hope this helps
>
> vai
>
>
> were u able to get ur matlab program to work in the
> 6711DSK??
>
> if you havent then have a look at the following web
> page:
> http://eceserv0.ece.wisc.edu/~morrow/software/
>
> you need "TMS320C6X11 DSK to Matlab direct interface
> software"
> save the zip file and just extract it in to the
> folder tat you have the m-file, there
> is few examples to get you started...
>
> if you have found another method let me knw aswel!
> becas im trying to do the
> same thin
>
> hope this helps
>
> vai
>
If u can try to figure out something from this, that would be great for
you.
I did something with this, but don't remember properly what i have
done.....sorry!!!.But forsure that there is one software for the direct linkage
of Matlab to 6711.
Hope you get it done.
Thanks,
Pranav
sreenivas s <s...@yahoo.co.in> wrote:
hi
I don't think it is possible in MATLAB.
It is possible in simulink if you have your .mdl files.
regards
sreeni
edznin84 wrote:
I'm doing a project regarding phase vocoder technique. I already have
the matlab m-files. is there any simple way to convert those m-files
so that it can be run in DSK 6711? :)
__________________________________________________
Reply by ●April 27, 20052005-04-27