Hi, all DSP friends.
I am using XDS510PP emulator connected with a DSP board. I have a code
which can be run successfully on the target DSP. When I try to profile a
loop, enable a loop in the profile setup. An error message appeared as
following.Anybody can give me some hint.
Can't Set Breakpoint at 0x836f4: Error 0x00000008/-1076 Error during: Break
Point, Cannot set/verify breakpoint at 0x000836F4 Sequence ID: 7 Error
Code: -1076 Error Class: 0x00000008
Breakpoint Manager: Attempting to set a hardware breakpoint instead
[This e-mail is confidential and may be priviledged. If you are not the
intended recipient, please kindly notify us immediately and delete the
message
from your system; please do not copy or use it for any purpose, nor disclose
its contents to any other person. Thank you.]
---ST Electronics Group---
Error message when I profile a loop using a emulator.
Started by ●August 22, 2005
