Dear all,
Currently, I am faced with the same problem, the leds keep on blinking at the
end of swiching up the DSK. I have tested with the confidence test and all
parameter are successfull. Try to do the POST test, got struck at led 2
(external SDRAM). After changing the value of SDRAMCTL, then the POST test is
ok. However, if the board is reset of switch on, the leds are still blinking
again. Anybody knows what's the problem with this matter?
Nash
>
>
>
> Hi all,
>
>I am having a problem with the POST when I put
>power-on the DSK,I tried to re-programming the flash
>memory but I did not obtain good results. The leds
>keep blinking. I run the confidence test results
>passed.
>
>Thanks,
>
>David Rojas
>
>
>
>
>______________________________________________________________________
>Correo Yahoo! - 6MB, m protecci contra el spam Gratis!
> http://correo.yahoo.es
>
>
>
>
>
