I'm trying to connect osciloscope to the 78th pin of External
Peripheral Interface and observe the ECLKOUT signal, but there is
nothing. Should I configure something before observing this signal? I
have DSK with C6713 processor.
problem with ECLKOUT
Started by ●February 8, 2007
Reply by ●February 13, 20072007-02-13
I'm trying to connect osciloscope to the 78th pin of External
>Peripheral Interface and observe the ECLKOUT signal, but there is
>nothing. Should I configure something before observing this signal? I
>have DSK with C6713 processor.
Some interface signals are disabled unless a daughter card is plugged in. The daughter card pulls down to ground the pin named DC_DET. You should pull it down if you want to enable the logic signals on the external interfaces. To avoid problems with your daughtercard read carefully the manual first!
>Peripheral Interface and observe the ECLKOUT signal, but there is
>nothing. Should I configure something before observing this signal? I
>have DSK with C6713 processor.
Some interface signals are disabled unless a daughter card is plugged in. The daughter card pulls down to ground the pin named DC_DET. You should pull it down if you want to enable the logic signals on the external interfaces. To avoid problems with your daughtercard read carefully the manual first!