Hi all, I am trying to program a TMS320F2801 DSP, using the On-Chip Flash Programmer Plug-In v1.12.0 for CCS_v3.1 with the XDS510usb emulator. But when I open de Flash Programmer Plug-In, all buttons are disabled except the unlock button. Nevertheless the CPU I am using is new so now password can be programmed. To be 100% sure I replaced the CPU by another new CPU and the same problem occurred. Is there something I am forgetting? Could it be a setting in the plug-in or in my source code?
Flash Programmer Plug-In problem
Started by ●February 13, 2006
Reply by ●February 15, 20062006-02-15
hi, do you see the password as FFFF in all the boxes above the unlock button ? if so , u only need to click the unlock button and then the flash programming utility will open up and all the other areas are activated. also see to it that the password is never set to all 0000 this will lock the processor hope this works bye --- bartluypaert@bart... wrote: --------------------------------- Hi all, I am trying to program a TMS320F2801 DSP, using the On-Chip Flash Programmer Plug-In v1.12.0 for CCS_v3.1 with the XDS510usb emulator. But when I open de Flash Programmer Plug-In, all buttons are disabled except the unlock button. Nevertheless the CPU I am using is new so now password can be programmed. To be 100% sure I replaced the CPU by another new CPU and the same problem occurred. Is there something I am forgetting? Could it be a setting in the plug-in or in my source code?