Forums

CCS "Cant Initialize target CPU" error

Started by sahing8 July 24, 2006
I have recently installed CCS 2.21 and downloaded the latest drivers,
but when I start CCS I get the following error:

DSP Device Driver error
Cannot Initialize target CPU
error at mem loc 0x0000000

I am currently using a C5510 DSP and I'm sure my hardware works
because when I set up my target chip and emulation on another PC which
was previously used to program the chip, everything works. When I run
Sdconfig the test runs perfectly. I am also farely positive my
configuration I have selected is right (c55xx parallel port emulator
from spectrum digital). My emulation is SPI515. Any suggests would
greatly be appreciated. Thanks