Hi all i have recently switched to VDSP ++ 3.0 but my target board is same as earlier one. balcktip ex 21060 sharc based board.also i ahve chnged my emulator to latest one which can support tiger sharc boards also. i used to collect data from serial port for more than 100 ms at the rate of 5 Mhz and then dump that data on hard disk using dump command in the older version and older emulator. but with this new tool when i try the same thing it does dont dump the full data but fills the file with zeros after few ms of data. how can it be rectified,if possible. regards sandeep |
Dumping Data problem
Started by ●May 6, 2004