Hello All,
I am using a ADSP-2181 EZ-KIT with Visual DSP++ 3.5 test drive version. When I
set the flag (SET FL1;)it only stays set until I do the next "Step Into" and
then it reset regardless of what the next line is. If I do a "Run to cursor" the
flag will stay set until I do the next "Run to cursor" or "Step into". If I run
the code in a "Simulator Session" the code works ok, but in a "EZ-KIT lite via
COM port session" I get this problem.
Is there any way I get the flag to stay set and debug the code with single
steps. Is this normal behaviour for an ADSP-2181 EZ-KIT.
Regards Stephen
