Hi all,
May I know which capture units corresponds to which PWMs of EVA and EVB?
I know that EVA has 3 capture units, CAP1, 2 and 3. Similarly for EVB CAP4, 5
and 6 and time base can be chosen based on the values in CAPCONA/B registers.
Incase, if I would like to use CAP1 for capturing the rising edge of CMPR1 and
CAP2 for capturing the rising edge of CMPR3, How do I ensure that? Can any one
of you answer me?
Many Thanks in advance.
Naayagi
OMAP35x EVM jump-starts low-power apps
The modular and extensible OMAP35x Evaluation Module (EVM) enables developers to
start building applications based on the OMAP35x architecture:
http://www.DSPRelated.com/omap35x
capture units of F2812
Started by ●May 28, 2008
Reply by ●May 29, 20082008-05-29
connect the hardware output pin of CMPR1 that is port8 pin9 on ezdsp board to
the cap1 pin etc
this should do what you want
but it can be done purely through software as well
n...@gmail.com wrote:
Hi all,
May I know which capture units corresponds to which PWMs of EVA and EVB?
I know that EVA has 3 capture units, CAP1, 2 and 3. Similarly for EVB CAP4, 5 and 6 and time base can be chosen based on the values in CAPCONA/B registers.
Incase, if I would like to use CAP1 for capturing the rising edge of CMPR1 and CAP2 for capturing the rising edge of CMPR3, How do I ensure that? Can any one of you answer me?
Many Thanks in advance.
Naayagi
OMAP35x EVM jump-starts low-power apps
The modular and extensible OMAP35x Evaluation Module (EVM) enables developers to start building applications based on the OMAP35x architecture: http://www.DSPRelated.com/omap35x
this should do what you want
but it can be done purely through software as well
n...@gmail.com wrote:
Hi all,
May I know which capture units corresponds to which PWMs of EVA and EVB?
I know that EVA has 3 capture units, CAP1, 2 and 3. Similarly for EVB CAP4, 5 and 6 and time base can be chosen based on the values in CAPCONA/B registers.
Incase, if I would like to use CAP1 for capturing the rising edge of CMPR1 and CAP2 for capturing the rising edge of CMPR3, How do I ensure that? Can any one of you answer me?
Many Thanks in advance.
Naayagi
OMAP35x EVM jump-starts low-power apps
The modular and extensible OMAP35x Evaluation Module (EVM) enables developers to start building applications based on the OMAP35x architecture: http://www.DSPRelated.com/omap35x
