>I have had this problem before and it is a bug on the DSK. There are
two >ways around it, The first is to ground all of the parallel port data pins coming off the dsk. The other is to Switch off (up) Switch #1 on SW1, This disconnects the parallel port from the DSK. I suggest the second. Joel >________________________________________________________________________ >________________________________________________________________________ > >Message: 2 > Date: Wed, 04 Sep 2002 07:23:31 -0000 > From: "satish_tvs" <> >Subject: problem with flash programming > >hello, > >i have one application. i have created .hex file and programmed flash >using flash burn utility. when i have removed jp2 and reset the dsk, >application is running fine. but if i remove my parallel port >connection and reset the dsk once again, the application in the flash >is not running. When dsk board is connected to parallel port flash >booting is fine. but if i remove parallel port then flash bootin is >not taking place. If any body has experienced same problem, please >help me. > >thank u, > >satish |
Re: problem with flash programming
Started by ●September 4, 2002
Reply by ●September 4, 20022002-09-04
hello, i have one application. i have created .hex file and programmed flash using flash burn utility. when i have removed jp2 and reset the dsk, application is running fine. but if i remove my parallel port connection and reset the dsk once again, the application in the flash is not running. When dsk board is connected to parallel port flash booting is fine. but if i remove parallel port then flash bootin is not taking place. If any body has experienced same problem, please help me. thank u, satish |
|